hid headlights

Last edited by a moderator:
Flipswitch said:
Disconnect drls

http://forums.nasioc.com/forums/showthread.php?t=1866966

I'd recommend a wire harness to go from your stock bulb plug to the hid kit

Tapping into the low beam & ground tabs

I'm pretty sure you have a 9007

http://www.hidkitswarehouse.com/images/90049007.jpg

Just be careful not to hit your highs or bump the flash to pass or your lights will cut out

& a diy if you want a retrofit to have a bixenon retrofit

http://forums.nasioc.com/forums/showthread.php?t=2369555
Click to expand...
so if i accidnetly tap high beams my lights will kill out?  like will they go out temporarily or will they burn out?

 
It'd just be temporary. The power will go from the low beam circuit to the high beam circuit. The hid kit you have would not have any power to it. Same as if you turned your lights off. Turning your low beams back on would re-power the hid but they do take a few seconds to warm up. It just wouldn't be much fun at highway speed is all. From what I've heard/read it's not good to flip power on & off quickly as it will shorten the life of the bulbs & ballasts.

 
no worries
default_additional_thumbsup.gif


 
You must log in or register to reply here.
Back
Top