DrakeHale33
New member
I'm going to be replacing my front rotors and pads this weekend and am searching for a DIY to guide me through the process. I plan on using this DIY
NorthUrsalia.com: Changing Your Brakepads
but I have a couple of questions. Should I remove the cap from the fluid reservoir to relieve pressure when compressing piston or will they "roll on" like outlined here. Will I need to bleed the brakes either way? Is it possible to assemble the pads as outlined here? Is there a better DIY I should use? I want to do the job efficiently as its getting cold!
Also in my front driver side when turning right I am getting a high-pitched rotational squeak intermittently, however it is becoming more common now. I have read it may be the dust sheild rubbing, and it seems like it is too high pitched to be a wheel bearing as it is a squeak/squeal and not a contanst howl/roar. So any ideas of where I can look while its pulled apart would be great.
99RS
5spd
ABS brakes
Thanks guys!
NorthUrsalia.com: Changing Your Brakepads
but I have a couple of questions. Should I remove the cap from the fluid reservoir to relieve pressure when compressing piston or will they "roll on" like outlined here. Will I need to bleed the brakes either way? Is it possible to assemble the pads as outlined here? Is there a better DIY I should use? I want to do the job efficiently as its getting cold!
Also in my front driver side when turning right I am getting a high-pitched rotational squeak intermittently, however it is becoming more common now. I have read it may be the dust sheild rubbing, and it seems like it is too high pitched to be a wheel bearing as it is a squeak/squeal and not a contanst howl/roar. So any ideas of where I can look while its pulled apart would be great.
99RS
5spd
ABS brakes
Thanks guys!