Need Ideas!!

[Subysaurus Rex]

i just picked up an "I" emblem and i cant figure out how i can attach the bastard. it has no holes or anything to bolt to, only 3M crap on the back. but the gamebreaker is, i want it attached to my mesh. any ideas?

 

[4WRXter]

I adhered something like that to the mesh in the forester grille with aluminum tape. Cut the tape into small enough strips to conform to the mesh and stick to the back of the "i" emblem.

Ours has been on through a couple of years.

 

[Spiller1327]

5 min epoxy works wonders. If you stir it up and let it sit a little while. 2 mins or so and let it tack up a bit then paste it onto your badge and stick it to the mesh. Will hold forever.

 

[spartan5]

^^^^^This FTW^^^^