KamB
Kam Berry
So I built my own exhaust last night, header to tailpipe out of a 10' section of Napa pipe. Got the pipe and it occurred to me I didn't have a pipe bender handy. Pie slice method? Nah, takes too much welding for the amount of wire I had left at 9 at night. But, I just got a new engine hoist. Well, off it went. I'm going to post pics once I get home. For now, ill get this thread up and try to add them on my iPhone. Basically, u slide the pipe under the legs of the hoist, I put a snowmobile belt around the pipe and cranked up on it with the lift arm. The belt makes it so that it can flex and give a nice rounded bend, not a pinched off crease. Worked shockingly well. I was amazed. Did my whole exhaust this way And it came out perfect. Of course there is the safety hazard of the belt snapping, but ehhh. It worked good! Ill probably get crap for this but for people that don't want to pay to get a exhaust done, it works fine and is free if you have the parts.