Apollyon12
Active member
I wonder if JB Weld would hold well enought to seal the hole permantently. Then use another oil galley plug hole.
EPOXY IS GOING TO BE MY FRIEND
- Thread starter iBChunkyboy
- Start date
Chris
YARRR SUBY MONSTER!!
Yea, and what happens when it doesn't work? That's a fairly large opening for JB weld to seal up. When it pops out you're gonna chooch the motor.
I must not be seeing the picture on my phone but I did see it on Facebook. That's really screwed
jaKe
>>><<<>>><<<
I have painted bolt threads with jb weld before and inserted into broken parts,clamped and let sit. all was well. but being such important oil pressure make sure you keep close eye on pressure.
i-wagon
Well-known member
I'd pay someone to tig it first
Meyagi
I'm a hack
the aluminum is so contaminated with oil you will never be able to tig that
KamB
Kam Berry
He already blew the motor once from no oil... Not like a pressure switch is any good anyway.
Didn't the dealer replace your block? Why not ask them about it since, presumably, they were the ones to over tighten it?
Didn't the dealer replace your block? Why not ask them about it since, presumably, they were the ones to over tighten it?
Meyagi
I'm a hack
im pretty sure the switch was leaking and he went to replace it himself and this happened according to what ive seen on fb
skipow
New member