TheNailman
Warcock
Hello all. I have a potentially silly question regarding the install of my EWG setup, and running it pre-tune.
For Reference, I'm running a Vf23 Turbo, with an Grimmspeed EBCS. the EWG Is a Grimmspeed up/ TIAL 38mm setup. i have the wastegate bracket from GS as well.
so. . . .
can i just install the EWG setup, and run the lines from the ebcs before going to get tuned? or is there a way i should hook it up so it just runs spring pressure off the WG? anyone have a handy mspaint diagram showing the suggested routing?
thanks in advance, hope this made sense. kinda crossing over into new territory here.
~Nailman
For Reference, I'm running a Vf23 Turbo, with an Grimmspeed EBCS. the EWG Is a Grimmspeed up/ TIAL 38mm setup. i have the wastegate bracket from GS as well.
so. . . .
can i just install the EWG setup, and run the lines from the ebcs before going to get tuned? or is there a way i should hook it up so it just runs spring pressure off the WG? anyone have a handy mspaint diagram showing the suggested routing?
thanks in advance, hope this made sense. kinda crossing over into new territory here.
~Nailman