GClark
New member
Not as mysterious with the water low.
Gremlins
- Thread starter -=Lobstah=-
- Start date
Ryan
New member
^Doesn't even look like a real photo
-=Lobstah=-
Active member
UPDATE: Gremlins lost
The problem - 1 of 2 (or both) things, either the flywheel was warped to begin with, or tech at NAPA took a tad bit too much when resurfacing the old flywheel. The difference between new and old was about .040. Soooo, slapped a new flywheel on and it runs great now. The car has left the garage earlier today....
The problem - 1 of 2 (or both) things, either the flywheel was warped to begin with, or tech at NAPA took a tad bit too much when resurfacing the old flywheel. The difference between new and old was about .040. Soooo, slapped a new flywheel on and it runs great now. The car has left the garage earlier today....
jcovey2.5
New member
:golf clap:
Ryan
New member
Along with Eddie's car, Lobstah installed new group n motor and trans mounts on mine, and we also did a compression test! Good work as usual.
Oh and btw Sergei, those compression numbers we saw are completely normal for the hybrid setup. Did some research on it. Bren says they are fine as well.
Oh and btw Sergei, those compression numbers we saw are completely normal for the hybrid setup. Did some research on it. Bren says they are fine as well.
-=Lobstah=-
Active member
that's what i thought....
Ryan
New member
Good stuff
Iboc_C64
New member
Argh. I get that error in excel evey once in a while, I also get it in Auto-Cadd if macros are on and in PLS-CADD if the program Facks up.See it's my luck, i make a thread and warp the time-space continuum... I guess i'll just stand in the corner and sob for a while
(I hope i never have to divide by zero)